Installation Note E8362-90004 21
Step 9. Install the Remaining New Hardware
Install the A23 and A24 Detectors (Refer to Figure 13.)
1. Place the A23 and A24 detectors on top of the brackets in the analyzer. Be sure to orient
them as shown.
2. Install two screws (item
①) in each detector to secure them to the brackets.
3. Connect the wrapped wire control cables from the A23 and A24 detectors:
• A23 detector to A16 test set motherboard J5 (R1 DET)
• A24 detector to A16 test set motherboard J6 (R2 DET)
Install the A21 SOMA 50 (Refer to Figure 13.)
1. Place the A21 SOMA 50 in position in the analyzer. Be sure to orient it as shown.
2. Install four screws (item
②) to secure the SOMA 50 to the A16 test set motherboard.
3. Connect the A21 SOMA 50 ribbon cable to A16 test set motherboard J4 (SOMA50).
Figure 13 A23 and A24 Detectors and A21 SOMA 50 Installation
To Next Page
Loading...
Need help?
General
