86 Chapter 2
Front-Panel Key Reference
Display
number to be created or edited using
the numeric keypad, then Press
Enter,
or use the knob, Tab or step keys to
move to an existing point. After
selecting a point,
Frequency (or Time)
becomes active.
Key Access:
Display, Limits, Limit 1 or
Limit 2, Edit
Frequency
(The key label is Time if
XAxisUnits(Time) has been selected.)
Allows you to enter the frequency
value for a limit point. After entering a
value, the limit table is sorted to place
the frequency or time in the correct
order. For a new point,
Amplitude
defaults to 0 dBm and
Connected to
Previous Pt
defaults to Yes. Amplitude
then becomes active.
Key Access:
Display, Limits, Limit 1 or
Limit 2, Edit
Amplitude
Allows you to enter the amplitude
value for the current limit point. After
entering a value,
Connected to Previous
Pt
becomes active. If a Tab key is
pressed without entering a value, the
current
Amplitude and Connected to
Previous Pt
values of the point are
selected. If Tab ā is pressed, the point
number automatically increments to
allow entry of the amplitude of the next
point, or if a new point, to allow
Frequency to be entered for the new
point.
Key Access:
Display, Limits, Limit 1 or
Limit 2, Edit
Connected to Previous Pt
Yes No
Allows you to determine whether the
current point will be connected to the
previous point. No limit testing is
performed between disconnected
points. Pressing this key when the
Connected field is selected toggles the
To Next Page
Loading...
Need help?
General
