1260 Infinity II Binary LC System - Manual and Quick Guide 7
Introduction
1
Features of the Agilent 1260 Infinity II Binary LC
Features of the Agilent 1260 Infinity II Binary LC
With an operating pressure of up to 600 bar, the 1260 Infinity II Binary Pump
is compatible with HPLC and UHPLC, i.e. handling 2.1, 3, and 4.6 mm ID
columns over the flow rate range (up to 5 mL/min). Gradient formation is
based on a high-pressure mixing principle.
Ultralow carryover – The 1260 Infinity II Multisampler is designed for low
carryover, you can take clean to a whole new level with the multi-wash
capability, cleaning all relevant injection parts between runs. This
sophisticated, integrated feature flushes the injection needle outside with
three solvents, and uses seat back flush procedures to reduce carryover to less
than 9 ppm.
Dual-needle injection – By running samples alternately through one or the
other injection path, you can reduce cycle times to mere seconds, virtually
eliminating conventional wait times—whether for large volume loadings or
flushing procedures.
Higher sample capacity per benchspace – Using shallow well-plate drawers,
the 1260 Infinity II Multisampler takes a maximum load of 16 microtiter plates
and up to 6144 samples—the most of any single system.
Advanced column capacity for up to 4 columns in a single 1260 Infinity II
Multicolumn Thermostat delivering best flexibility for column switching.
Fast and easy connections with InfinityLab Quick Connect fittings to save time
and trouble.
1260 Infinity II DAD HS Detector delivers lower detection limit and higher
data quality for more confidence.
Seamless integration in your chromatography data system: Agilent’s
Instrument Control Framework (ICF) enables smooth control of Agilent LC
instrumentation through third-party chromatography data systems.
To Next Page
Loading...
Need help?
General
