Agilent Technologies InfinityLab LC Series Installation Manual

10
3 Using the 4 mm wrench and the 5/16“ wrench for counter-holding, unscrew
the valve to needle tubing from the needle.
4 Un-clip the tubing from the bottom of the needle carrier assembly.
5 Slide the tubing through the hole in the needle carrier assembly (from
bottom to top) (1.) and out of the holder in the z-arm assembly (2.).



Agilent Technologies InfinityLab LC Series Specifications

General

Brand	Agilent Technologies
Model	InfinityLab LC Series
Category	Laboratory Equipment
Language	English