1Getting Started
20 N1913/1914A Installation Guide
Remote Interface Configurations
The power meter can be remotely controlled by LAN, USB, and GPIB
(IEEE488) programming interfaces. This section shows you how to set the
interface configurations.
Only one interface should be used at any one time.
• Agilent IO Libraries Suite for Windows 98/2000/ME/XP. For information
and to install, use the Automation- Ready CD with Agilent IO Libraries
Suite which is shipped with the power meter.
• E2094M Agilent IO Libraries for Windows 98/NT/2000/ME/XP. You can
find information and install this application via the Web at
www.agilent.com/find/iolib.
• You can also access other information about Agilent IO Libraries at
www.agilent.com/find/iolib.
For more information on configuring the remote interface connectivity,
refer to the Agilent Technologies USB/LAN/GPIB Interfaces Connectivity
Guide. If you have installed the IO Libraries Suite, you can access the
connectivity guide via the Agilent IO Libraries Control icon. Alternatively,
you can access the connectivity guide via the Web at
www.agilent.com/find/connectivity.
To connect the power meter to your PC, configure and verify your connection, you can use
the Agilent IO Libraries Suite, the E2094M Agilent IO Libraries for Windows, or an
equivalent.
To Next Page
Loading...
Need help?
General
