Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 275
Creating and Downloading Waveform Files
Programming Examples
300 END
Program Comments
10: Program file name.
20 Sets the number of points in the waveform.
30: Defines arrays for I and Q waveform points. Sets them to be integer arrays.
40: Sets HP BASIC to use degrees for cosine and sine functions.
50: Sets up loop to calculate waveform points.
60: Calculates I waveform points.
70: Calculates Q waveform points.
80: End of loop.
160 and 210: The I and Q waveform files have the same name
90 to 300 See the table on page 271 for program comments.
To Next Page
Loading...
