25
Memory Clearing, Sanitization and Removal Procedures
Archiving and Restoring Factory Calibration Data Files
Archiving and Restoring Factory Calibration Data Files
This section describes how to archive ("back up") the instrument’s factory calibration data to an external
USB memory device, or restore the calibration data from an external memory device.
Tools Required
To perform backup or restore operations, you need:
• a mouse with a USB interface
• a portable memory device with a USB interface
• an alphanumeric keyboard with a USB interface
Data Backup or Restore using Alignment Data Wizard
The Alignment Data Wizard is launched directly from the instrument application software interface. You do
not need to exit the application software before proceeding.
Follow the steps below to start the wizard:
1. Plug the mouse’s USB cable into one of the instrument’s USB ports.
2. Plug the USB memory device into another of the instrument’s USB ports.
3. Plug the USB keyboard into another of the instrument’s USB ports.
4. Press System > Alignments > Backup or Restore Align Data...
5. The Alignment Data Wizard dialog appears, as shown in Figure 6-2 below:
To Next Page
Loading...