XGS-600 Gauge Controller
DRAFT 4/15/14
7
Preface
Hazard and Safety Information
This manual uses the following standard safety protocols:
WARNING The warning messages are for attracting the attention of the
operator to a particular procedure or practice which, if not
followed correctly, could lead to serious injury.
CAUTION The caution messages are displayed before procedures, which
if not followed, could cause damage to the equipment.
VOLTAGE Alerts the user to the presence of uninsulated dangerous voltage
within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
NOTE The notes contain important information.
This product must only be operated and maintained by trained personnel. Board
installation/replacement requires a properly trained service technician.
Before operating or servicing equipment, read and thoroughly understand all operation/
maintenance manuals provided by Agilent Technologies. Be aware of the hazards
associated with this equipment, know how to recognize potentially hazardous conditions,
and how to avoid them. Read carefully and strictly observe all cautions and warnings. The
consequences of unskilled, improper, or careless operation of the equipment can be serious.
In addition, consult local, state, and national agencies regarding specific requirements and
regulations. Address any safety, operation, and/or maintenance questions to your nearest
Agilent Technologies office.
To Next Page
Loading...
