GB
10
with heavy reinforcement, a slower speed may be required.
* If a slower speed is required, select a larger diameter setting than the
actual bit.
* If a faster speed is required, then select a smaller diameter setting
than the actual bit.
CHANGING BETWEEN mm and inch DISPLAY
With the motor plugged in, but not running, press and hold the Rebar
Assist Button continuously for 4 seconds. The displayed units will
change. To change back, repeat the process.
ELECTRONIC SPEED SETTINGS WITH CORRESPONDING RATED LOAD SPEEDS
4)MOUNTING TO A DRILLING STAND (NOT INCLUDED)
Warning: Do not attempt to mount to a rig that does not have a perfectly fitting mounting system.
This motor has 2 mounting possibilities. It can use an AGP system six-bolt mounting plate, or just use the lower
4 bolt holes, which are in a standard bolt hole pattern for attaching most types of 4-bolt mounting plates.
Use the mounting plate suitable for the drill stand you are using to mount your drill motor to your stand. (If
there is not enough clearance between the motor's electronics box and the drill stand, use the optional 40mm
Speed Setting Ø (mm) Rated Load rpm Speed Setting Ø (inches) Rated Load rpm
500 mm 220 /min 20" 220 /min
450 mm 225 /min 18" 225 /min
400 mm 230 /min 16" 230 /min
350 mm 240 /min 14" 240 /min
325 mm 253 /min 13" 253 /min
300 mm 274 /min 12'' 274 /min
275 mm 300 /min 11" 300 /min
250 mm 329 /min 10'' 329 /min
202 mm 407 /min 8" 407 /min
182 mm 451 /min 7" 451 /min
172 mm 478 /min 6.5" 478 /min
162 mm 507 /min 6.25" 507 /min
152 mm 525 /min 6" 525 /min
142 mm 532 /min 5.5" 532 /min
127 mm 540 /min 5" 540 /min
122 mm 540 /min* 4.5" 540 /min*
102 mm 540 /min* 4" 540 /min*
(* Torque reduced to protect bit)
Diameter Selector Buttons
Rebar Assist Button
Motor On/O Button
LED Load Indicator
Bit Threading Button
To Next Page