Aiphone GT Video-intercom System Guide
GT Door Stations
Are GT Door Stations different to GT Entrance Stations?
Yes. While GT entrance stations are located at the entrance to a building, set of
units, or office complex, and allow a visitor to contact any one of the many tenants,
GT door stations:
● Are located immediately outside the tenant's door.
● Allow a visitor standing outside a tenant's door to contact that tenant only.
● Use different video intercom modules than entrance stations.
● Can replace old-style tenant door peep holes.
● Only work with Aiphone GT-2C master monitor stations.
A GT door station may only be used outside an apartment, unit, or office, if the GT
master monitor station used by that tenant is an Aiphone GT-2C. Other GT master
monitor stations do still however support a door bell button located immediately
outside the tenant's door (as does the GT-2C as well).
There are four different door stations that may be used with the GT video
intercom system.
Video intercom camera door stations from the single residence Aiphone JK Series
may be used with the GT-2C master monitor station, when placed immediately
outside the tenant's door. Choose from the flush mount stainless steel plate JK-DVF
door station, the JK-DV surface mount zinc die-cast (left) door station, or the plastic
surface mount JK-DA. All of these JK door stations feature a 170° wide angle digital
PTZ camera, similar to that used in the GT video intercom entrance stations.
If the tenant requires an audio-only door station, then the Aiphone GT-D door
station may be used.
To Next Page
Loading...
Need help?
General
