48
How to use
Monitoring
3
Scan Monitoring
Video and audio of the following stations can be monitored automatically in order.
• Entrance Station
• Door Stations of that are registered in Outside Areas
• Door Stations that are registered in the same Unit
• Network Camera
This function can be configured in “How to configure Scan Monitoring (→page 101)”.
For stations without cameras, only audio will be heard while monitoring.
Audio of the station that initiates monitoring cannot be heard by the other party during monitoring. However, the other
person may be notified that they are being monitored (a notification tone or flashing LED), depending on the
configuration of the other station.
If the station of the other party is in the following condition, monitoring cannot be performed.
• Outgoing call
• Incoming call
• Incoming page
• Communicating
• Set to refuse monitoring
1. Tap [Monitor] on the Home
screen.
2. Tap [SCAN MONITOR].
• The calling tone plays until scan monitoring
begins.
Important
• The Scan Monitor operation continues until it is ended. If the Scan Monitor operation is continuously running, the life of the
LCD Display may be shortened.
To Next Page
Loading...
