- 7 -
● Mounting in a gang box
※1: Install in a place where the unit can be accessible.
※2: When mounting the unit, be careful that no cables become caught between the unit and the mounting
bracket.
※3: A wire diameter of PE 0.65 mm (22AWG) and a CE1 type crimp terminal are recommended. If any other
types are used, those types of cable may not fit in the switch box.
1
2
4
3
Attach the unit with the
fastening screw.※2
Position the mounting bracket with
facing up and affix.
Fastening screw
Unit
Mounting bracket (included)
3-gang box ※1
Low-voltage lines
Mounting screws (included) x 4
[For mounting on wooden wall, etc.]
Wood mounting screws (included) x 4
Cat-5e/6 cable
Option connectors (included)
Join the option connectors (included) to the low-voltage lines
and insert the option connectors and Cat-5e/6 cable to the
unit.※3
Cat-5e/6 cable
Option connectors (included)
Unit
[Back]
Panel
Attach the panel.
Refer to page 6.
To Next Page
Loading...
