Aiphone KB-3MRD Installation Manual

830762 (E) P0212 AF 54192
AlPHONE
VIDEO SENTRY COLOR TILT
COLOR TILT VIDEO ENTRY SECURITY INTERCOM
Modsis: KB~3MRDj Master station with monitor
KB-3HRD, Sub station with monitor
INSTALLATION MANUAL
This Manual and the Markings on the product contain
various symbols in order that the product can be used
safely and properly, and that the installer and user are
protected from injury and property damage.
The following precautions must be thoroughly read and
understood before proceeding.
PRECAUTIONS ON INSTALLATION & WIRING
KB-3MRD
KB-3HRD
/K WARNING Negligence could result in death or serious injury.
/i\ CAUTION Negligence could result in injury or damage to property.
The following precautions also apply to KB-3HRD sub station with monitor.
WARNING 1. Do not connect any power source other than specified to terminals +, - on KB-3MRD.
Fire or damage to the unit could result. ^
2. Do not open KB-3MRD. High voltage is present inside, and it can cause electric shock. ^
3. Do not change or alter KB-3MRD. It can cause fire or electric shock. ^
4. Make sure wires are connected properly before plugging in power supply. ^
5. Keep the KB-3MRD unit away from water or any other liquid. Fire or electric
shock could result.
6. Do not put any forcible strength on the video monitor. Damage may result. ^
7. Keep AC plug away from moisture or dust.
8. Keep AC cord away from being marred or crushed. ^
9. Do not plug or unplug with wet hands.
10. D o not put any metal into KB-3MRD through openings. It can cause fire, ^
electric shock or unit damage. ^
CAUTION ^ install or make any wire terminations while power supply is plugged in. ^
It can cause electrical shock or damage to the unit.
2. Do not manually hold down hook switch to verify chime volume. It sounds very ^
loud in the handset, and can cause hearing damage.
3. Mount KB-3MRD on wall in a convenient location, but not where it could be a
bumped or jarred. “
4. In case of electrical storms, unplug power supply from AC outlet. It can cause A
fire, electric shock, or power surge damage. ^
5. Do not install KB-3MRD components in any of the following locations, as it may
cause the system to malfunction; ^
- High or extreme cold temperature area: under direct sunlight, near equipment
that varies in temperature, in front of air conditioner, inside a refrigerated area, etc.
- Places subject to moisture or humidity extremes.(bathroom, cellar, greenhouse, etc.)
- Places subject to environmental conditions, such as oil, dust, chemicals, salt, etc.
- Places subject to constant vibration or impact.
- Places where noise generating devices such as TV or radio are close by.
^GENERAL PRECAUTIONS
KB-3MRD equipment, except for KB-DAR, is designed for indoor use only.
Do not install outdoors.
KB-3MRD system is not operational during a power failure.
In areas where broadcasting station antennas are close by, intercom system
may be affected by radio frequency interference.
Keep all DC wiring at least 30cm(1') away from AC 100~240V wiring, fluorescent
lighting, or dimmer switches. Otherwise, cross AC wiring at a 90°angle.
Examples of Symbols;
GENERAL PRECAUTIONS: - A mark
indicates caution statement (incl. danger
and warning), which is specifically
shown inside.
I GENERAL INSTRUCTIONS: - • mark
indicates contents which demands a
specific action shown inside or attached.
0 GENERAL PROHIBITIONS: - 0 mark
indicates contents which prohibit a specific
action shown inside or attached.
I DISMANTLE PROHIBITIONS
MOISTURE PROHIBITIONS

Aiphone KB-3MRD Specifications

Operating Environment

operating temperature	0°C ~ 40°C
wiring distance to door	100m 200m
wiring distance to farthest monitor	50m 100m

Power

power source	24V DC
consumption	710mA
standby consumption	230mA

Weight and Dimensions

weight	900g
dimensions	185 (W) X 195 (H) X 84 (D) mm