Aiphone KB-3MRD - Monitoring Door Stations

3 INSTALLATION (continued)-
Mounting locations & Height
Do not install a video door station in the following
locations;
- Places subject to temperature/humidity extremes.
- Places from dust, vapor, smoke and chemicals.
- Places where a call is strongly backlit (white wall
is on the background).
- Places where direct sunlight or strong light comes
into the camera lens.
Image view area (approx.) when the door camera is tilted
*235cnn \
VERTICAL (tilting)
HORIZONTAL
Over view
50cm
( 20 " :
Mount the station so that the video
monitor comes at the user's eye level.
Setting
Place the dip switches to put the corresponding function into effect.
(1) Filling in directory
Open the directory pushing the cut edge. Fili in names with pen.
(2) Silencing chime tone
□ □
I
3 STUDY 4 KID 5 BEDROOM
On KB-3MRD & KB-3HRD:
Chime Tone Mute : To mute the chime tone from any door station,
move the switch to the Up position. To hear the chime, leave in the lower default position.
(3) White light on/off
On KB-3MRD only;
When ambient light is low (during night, etc.),
the white light on door station will turn on automatically
when door calls or during monitoring.
Chime
tone
{i
ON
t
for door 1
for door 2
for door 3
QQDn
1 2
_I
? 3
3
r
White light
ON
n
White light
☆
Adjustments
• in standby
Chime volume
In standby mode, press TONE button. Chime tone sounds
at mid level, and changes when the button is pressed.
MID (initially set) - HIGH - LOW - MID ...
When power switch is turned off or after power failure,chime volume will
return to MID position.
• while communicating
1
Receive volume
While communicating \N\\h door or another room station, press TONE
button. Pressing button repeatedly, the recieve volume changes:
STANDARD (initially set) - HIGH - VERY HIGH - STANDARD ...
Notes:
1. When acoustic feedback takes place in answering door, with receive
volume set to HIGH or EXTRA HIGH position, put the volume back
to STANDARD position.
2. Once receive volume is set, it will be in memory after communication.
(When power switch is turned off or after power failed, receive volume
will return to STANDARD position)
-5-