EasyManua.ls Logo

Air Lift Ride Control 59544 User Manual

Air Lift Ride Control 59544
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Technical Support
1-800-248-0892
Ext. 2
1
MN-612
(05606)
ECR 5714
by
P/N 59544
Please read these instructions completely before proceeding with the installation.
Figure 1
NOTE: Unbolt the lower bracket from the leaf spring if the vehicle
is to be serviced by a frame contact hoist. Not for off-road use.
Air Line
Driver-Side
Upper Frame
Bracket
Air Sleeve
Lower
Bracket
OUTBOARD
FORWARD
Note:
3/8" U-Bolt
Flat Washer
3/8"-16 Lock Nut
M10-1.25 or M10-1.50 Bolt
M10 Lock
Washer
1/2" Flat Washers
1/2" HHCS Bolt
P
art Nu
m
b
er
Lock Washer
1/4 Push-In
Elbow
Nylon Mounting Nut
Lower Bracket must
be installed with the
center slot offset to the
outside of the vehicle.
3/8" Serrated
Flange Nut
Driver Side Shown
The jounce bumper
attaches the bracket
to the frame.
Note:
Torque nut to no
more than 10 ftlbs.
evenly on both sides.
Stock
Jounce
Bumper
J Bolt
Note:
Frame
(L)
Question and Answer IconNeed help?

Do you have a question about the Air Lift Ride Control 59544 and is the answer not in the manual?

Air Lift Ride Control 59544 Specifications

General IconGeneral
Product TypeAir Spring Kit
Load CapacityUp to 2, 000 lbs
Adjustable Pressure5-100 PSI
MaterialRubber
WarrantyLimited Lifetime Warranty
AdjustabilityYes
InstallationNo Drill
Kit ContentsAir springs, air lines, fittings, and hardware
Included ComponentsAir springs, air lines, fittings, and hardware

Summary

Finished Installation

Maintenance

Minimum and Maximum Air Pressure

Specifies the minimum 5 PSI and maximum 100 PSI air pressure for the air springs.

Regular Air Pressure Checks

Advises to maintain normal ride height, keep at least 10 PSI, and check pressure weekly.

Air Leak Troubleshooting

Guide to check air lines and valve core with soapy water if an air leak develops.

Operating Tips

Adjusting Air Pressure for Ride Height

Adjust air pressure to maintain normal ride height for optimal ride and handling.

Vehicle Load and Safety Limits

Do not exceed vehicle manufacturer's load recommendations; check owner's manual.

Inflation Procedure

Add air in small quantities, checking pressure frequently as air springs inflate quickly.

Vehicle Lifting Precautions

Ensure system is unbolted from leaf spring when raising vehicle by frame to prevent damage.

Warranty Void Conditions

Failure to maintain minimum pressure or prevent bottoming out voids the warranty.

Related product manuals