Air Lift 88365 User Manual

Kits 57365 | 88365 | 89365
For maximum effectiveness and safety, please read these instructions
completely before proceeding with installation.
SERIES
Installation
Guide
TM
MN-1052 • (031711) • ECR 8949
Failure to read these instructions can result in an incorrect installation.
Dodge/RAM 1500

Air Lift 88365 Specifications

General

Product Type	Air Spring Kit
Load Capacity	Up to 5, 000 lbs
Adjustable Pressure	5-100 PSI
Air Line Fitting Size	1/4 inch
Compatibility	2011-2019 GM 2500/3500 HD Trucks
Minimum Height	5 inches
Maximum Height	12 inches
Recommended Pressure	Varies by load and application
Material	Rubber and steel
Weight	15 lbs

Summary

Installation Diagram

Hardware and Tools Lists

Common Parts Included in All 3 Kits

Lists all parts common to the 57365, 88365, and 89365 kits.

Unique Parts in Each Kit

Details parts specific to each LoadLifter 5000, Ultimate, and Ultimate Plus kit.

Tools List

Introduction and Safety Information

Important Safety Notice

Highlights crucial safety points regarding vehicle weight ratings and payload.

Installing the LoadLifter 5000 Series System

Getting Started

Steps to prepare the vehicle for installation, including removing coil springs and bumpers.

Assembling the Air Springs

Instructions for assembling the air springs with roll plates, brackets, and fittings.

Installing the Assemblies

Steps for mounting the assembled air springs onto the vehicle's axle and frame.

Installing the Air Lines

Installing Nylon Air Lines

Installing Braided Stainless Steel Air Lines

Installing the Heat Shield

Before Operating

Checking for Leaks

Procedure for inflating springs and checking connections for air leaks using soapy water.

Fixing Leaks

Steps to diagnose and repair leaks in air line fittings or inflation valves.

Installation and Post-Installation Checklists

Installation Checklist

Post-Installation Checklist

Product Use, Maintenance, and Servicing

Maintenance Guidelines