Why does my Aircare Humidifier display flashes “20”?
If your Aircare Humidifier display flashes “20”, it means the room humidity is lower than 20%. It will read actual humidity when the level comes up to 25%.
What to do if my Aircare Humidifier is leaking water?
If your Aircare Humidifier is leaking water, the cabinet may have been overfilled. Do not overfill the cabinet. The correct water level is indicated inside of the cabinet side wall, as there is a safety overflow hole in the rear of the cabinet.
What to do if my Aircare Humidifier is not producing enough humidity?
If your Aircare Humidifier isn't producing enough humidity, the wick might be old and ineffective. Replace the wick if it's clogged or hardened with minerals. Alternatively, the humidistat might not be set high enough; try increasing the humidity setting on the control panel.
Why does my Aircare Humidifier display flashes ”—“?
The display on your Aircare Humidifier might flash “—“ because the unit is initiating. The room humidity will display after initiation is complete. Alternatively, the room humidity may be over 90%. The display will remain until humidity drops below 90%.
What to do if my Aircare EP9 500 control panel does not respond and displays CL?
If the control panel on your Aircare Humidifier isn't responding and the display shows 'CL', the control lock feature is likely turned on. To deactivate it, press the Humidity and Speed buttons simultaneously for 5 seconds.
What to do if my Aircare Humidifier has an odor?
If your Aircare Humidifier has an odor, bacteria may be present. Clean and disinfect the cabinet following the care and maintenance instructions. You can also add an EPA registered Bacteria Treatment according to the instructions on the bottle. If the odor persists, it may be necessary to replace the wick.
What to do if my Aircare EP9 500 is producing too much humidity?
If your Aircare Humidifier is producing too much humidity, and condensation is heavy, the humidistat may be set too high. Try reducing the humidistat setting or increasing the room temperature.
How to fix Aircare EP9 500 Humidifier that does not operate on any speed setting?
If your Aircare Humidifier isn't operating on any speed setting: * Ensure the polarized plug is fully inserted in the wall outlet to provide power. * Refill the reservoir, as the fan won't operate without water. * Ensure the float assembly is correctly positioned as described in the manual.
Why does the light remain on in my Aircare EP9 500 Humidifier after turning it off?
The LED light stays on in the cabinet of your Aircare Humidifier whenever power is supplied. This is normal.
Crucial safety guidelines and warnings for operating the humidifier safely.
Step-by-step guide for assembling the humidifier, including casters, float, and wick.
Detailed steps for removing and replacing the evaporative wick.
Steps for regular cleaning using vinegar to remove scale and residue.
Lists common problems, their probable causes, and recommended remedies.
Outlines the two-year limited warranty for the unit and 30-day for wicks/filters.
General| Brand | Aircare |
|---|---|
| Model | EP9 500 |
| Category | Humidifier |
| Language | English |
To Next Page