AirCycler Bulb Eater 3 - Spinner Replacement Procedures

800.909.9709
www.AirCycle.com [18]
ATTENTION:
Only crushed lamps and filters, placed on top of the crushed lamps, can be inside the drum.
Do not place any extraneous materials or liquids in the drum. Presence of these materials with the crushed
lamp waste could result in very significant upcharges or potential return of the waste to your facility.
NOTE: Bulb Eater users in the state of Tennessee are required to ship spent filters in DOT containers separate
from the drums of crushed lamps.
ATTENTION:
Only crushed lamps and filters, placed on top of the crushed lamps, can be inside the drum
Do not place any extraneous materials or liquids in the drum
Spinner Replacement Procedures
Communicate/understand potential hazards by having operators review pages 24-29 of this manual and
complete online training program at www.BulbEater3Training.com
When the Crusher Motor exhibits excessive vibration, the spinner assembly should be changed.
Gloves and eye protection should be worn while changing the spinner.
With the Bulb Eater
®
3 on a clean, empty drum:
1. Carefully stand the Bulb Eater
®
3 on edge. Figure 1
2. With a 5/32” Allen wrench, loosen the set screw holding the spinner on the motor shaft.
3. Slide off the old spinner and replace with new spinner in the same position. Figure 2
4. Tighten the set screw firmly to secure the spinner to the motor shaft. Figure 3
Note: Another option would be to remove the chute safety cover and replace the spinner assembly.
FIG. 2
FIG. 3
2
FIG. 1
1
FIG. 2
FIG. 3
FIG. 1