800.909.9709
www.AirCycle.com [21]
Does the spinner assembly need to be changed?
The spinner chain assembly should be changed when uneven wear causes excessive vibration to the
machine.
Refer to the Maintenance & Troubleshooting section of the owner’s manual for spinner-changing instructions.
What do I do when my drum is full?
First, let the machine sit “off” for at least 15 minutes before opening the lid. This allows for dust to settle inside
the drum. Once the Bulb Eater
®
3 is removed from the top of the drum, it is strongly recommended that the
drum be resealed as quickly as possible (within 10 seconds of removal of machine from drum) to minimize
potential release of remaining mercury vapors present inside the drum.
Once your drum is full, call Air Cycle at 800.909.9709 or visit www.aircycle.com/services to schedule a pickup.
How can I order more filters or other replacement parts?
Visit www.aircycle.com or call 800.909.9709 or 708.344.7860 to order more filters and replacement parts.
What safety precautions should I take when operating the Bulb Eater
®
3?
Because of possible lamp breakage outside of the drum, suitable eye protection and protective gloves must be
worn at all times while the machine is in operation. Proper ear protection (such as the provided ear plugs)
should also be worn at all times when operating the Bulb Eater
®
3. Wearing steel-toed safety shoes and
disposal overalls is recommended when changing out drums or moving full drums around for storage or
pickup. Take care when lifting and moving drums of crushed lamps, as a full drum can weigh over 500 lbs.
Before using the machine it is extremely important for the operator to review and understand all instructions
and safety precautions. Refer to the Operation Instructions in this manual for detailed information and
procedures.
How should I clean up broken bulbs?
1. Carefully scoop up glass fragments and powder using stiff paper or cardboard — DO NOT use a
traditional vacuum or broom as these may spread the mercury-bearing phosphor powder.
2. Place fragments and powder in the drum with crushed lamps.
3. Use tape or a wet paper towel to clean up remaining fragments and powder.
4. Place tape or paper towel in a securely sealed zip-top bag and place bag on top of full drum of
crushed lamps with spent filters.
What regulatory restrictions apply to operating the Bulb Eater
®
3?
As a part of staying compliant with EPA and OSHA regulations, Air Cycle recommends that the operator of the
Bulb Eater
®
3 should be trained on how to properly operate and maintain the equipment and crush no more
than two full drums of lamps per 8-hour work shift in a well-ventilated work area. Users/operators of the Bulb
Eater
®
3 may opt to process more lamps given that appropriate monitoring is performed.
Crushing lamps is a regulated activity by the United States Environmental Protection Agency. Air Cycle
Corporation strongly urges all Bulb Eater
®
3 customers to thoroughly research all regulations that may apply to
crushing, storage, shipping, labeling, employee training, and other crushing-related activities at their facility.
Detailed environmental and regulatory information can be found in the Mercury Information appendix beginning
on page 24.
Visit www.bulbeater3training.com to complete the Bulb Eater
®
3 Certified Training Program
For additional online Bulb Eater resources visit www.mybulbeater.com
For More Information on the Bulb Eater
®
3 and
Air Cycle Corporation visit www.aircycle.com
To Next Page
Loading...