16
Notes:
Protect the drain cover and water stopper properly.
Move the unit carefully to avoid the leakage it is necessary.
Tilt the unit slightly backwards when draining.
Block the drain hole as soon as possible before the tray is full if it cannot hold all water in the unit to prevent the water
leakage and wet the floor or carpet.
Water stopper and drain cover must be tightly installed, to avoid new condensate to wet the floor or carpet when the
unit re-starts working.
CONTINUOUS DRAINAGE
1. Screw off the drain-cover & unplug the water stopper.
2. Connect drain-hole with φ13mm drain hose (If you need the plastic drainage pipe, please purchase it with outer
diameter 13mm and length according to the drainage distance), as deep as possible to avoid leakage.
3. Pull the drain hose to bathroom or outdoor.
Notes:
Drain hose must be installed when there’s no water in the tray.
It is suggested that not to use continuous drainage when unit is in COOL mode, to ensure enough water recycle in the
unit to enhance the system cooling effects.
It is suggested that to adopt continuous drainage when unit is in HEAT mode, to avoid frequent drainage.
Put the drain hose in an inaccessible place, not higher than drainage hole and keep drain hose straight without any
flexure.
Keep the drain cover and its stopper properly when continuous drainage is adopted.
CARE AND MAINTENANCE
WARNING
Be sure to turn off the unit and pull out the plug before maintain or send to service center.
SURFACE CLEANING
- Unplug the appliance before cleaning.
- Clean the unit surface with wet soft cloth and do not use chemical solvents such as alcohol and gasoline to avoid any
damage to unit. Any thinner, alcohol-glazer or other similar solvents is prohibited for unit cleaning.
- Clean the dirty air outlet or louvers with wet soft cloth and detergent. Any chemical solvent is prohibited to use for unit
cleaning or put such things near the unit for a long time.
To Next Page
Loading...