Use and maintenance manual Self-propelled aerial platforms Page 27
L) Oil warning light (models “D” and “E/D”);
M Air filter warning light (models “D” and “E/D”);
N) Motor head temperature warning light (models “D” and “E/D”);
O) Lifting/lowering lever;
P) Front roll-out deck extraction/retraction lever (OPTIONAL);
Q) Rear roll-out deck extraction/retraction lever (OPTIONAL);
R) Sliding platform extraction/retraction lever (OPTIONAL).
The key must be given to authorized personnel. Keep a duplicate key in a safe place.
Always remove the on/off key at the end of work shifts.
5.2.1.1 On-off key and control station selector (A)
The on-off key located on the ground control station is used to:
- turn ON the machine by selecting one of the two control stations:
- platform controls enabled with key switch set to “platform” symbol. Stable key position with possibility to extract the
key;
- ground controls enabled (for emergency operations) with key switch set to “chassis” symbol. Position with action to
be kept. When the key is released the machine is turned off.
- turn OFF the control circuits by turning it to OFF;
- turn ON the battery charger by turning it to OFF (models “E” and “E/D”).
5.2.1.2 Emergency STOP button (B)
By pressing this button the machine (as well as the heat engine on models “D”, “E/D” and “E/B”) is completely stopped; by
rotating it of 1/4 turn (clockwise) the machine can be turned ON by means of the ON-OFF key (see chapter 5.2.1.1).
5.2.1.3 Diesel/electric power selector (C)
Holding the ON-OFF key in position “ground controls” it is possible to select the type of power for the ground controls:
- If ELECTRIC is selected and the ON-OFF key is kept active in position “ground controls” the electric pump is started
while operating the ground controls;
- If DIESEL is selected and the ON-OFF key is kept active in position “ground controls” the Diesel engine can be started.
5.2.1.4 Heat engine starting switch (D)
Holding the ON-OFF key in position “ground controls” after selecting the DIESEL power, the diesel engine can be started by
means of the relevant switch.
- In “0” position the Diesel engine is off;
- In “3 sec” position the plugs pre-heating takes place (only for engines with plugs);
- In “Start” position the engine starts.
To Next Page
