AirTek ACentre-20 - Specifications

AIRTEK ACentre-20 User Manual V3.2
2
/17
Specifications
 Packaged machine dimension: 720*780*1285mm
 Unpacked machine dimensions: 644*731*1147mm
 Mains power supply: AC110V±10％~60Hz
 Compressor power: 3/8HP
 Max. refrigerant recovery speed: 0.25Kg/min. Patent pending SRR (Supreme Recovery Rate) system ensures
99% recovery rate
 Vacuum: pump capacity: 120L/min
 Evacuation time selection: 2-60 min
 Two flow-out ventilation fan, each 279CFM, to make air change rate14m³per minute in the cabin. Under any
circumstances that fan is stopped, the machine will be powered off
 When power switch is turned on, the machine holds on with 30 sec pre-ventilation, to make 7 air changes in
the cabin before the machine is powered
 Flush function: 8 minute flush for small and medium-sized A/C, with requirement of min. 4.5KG refrigerant in
equipment tank; 16 minute flush for big-sized A/C, with requirement of min. 6KG refrigerant in equipment
tank
 Used oil vessel: 400ml capacity, high transparency
 Refrigerant charging speed: Max. 2Kg/Min, liquid charging
 High capacity spin-on filter-drier: 600ml capacity, for recovering totally 100KG refrigerant
 Accuracy of refrigerant cylinder load cell: ±10g
 Accuracy of PAG / POE oil /Used oil bottle load cell: ±5g
 Refrigerant cylinder: 10KG, with heater band
 Machine maximum working pressure: 20bar with electronic high-pressure protection warning and safety
release valve
 Automatic Non-condensable purge (NCG) based on R1234yf pressure-termperature nature
 Display: 7’’touch screen
 Gauges: High side -1bar~30bar, Low side -1bar~16bar
 Digitally displayed cylinder pressure and temperature, Electronically controlled air purge
 Vehicle A/C database included
 Electronically monitoring and displaying system service intervals
 Thermal printer
 In-built HFO-1234yf refrigerant identification, accuracy 0.1%，identification time 120 seconds