Need help?Do you have a question about the AirTek SC 1000-A4 and is the answer not in the manual?
Inspect dryer for damage upon arrival and file claims for concealed damage immediately.
Follow safety guidelines such as never working on a pressurized unit or under power.
Locate in area with 50°-100°F ambient temp, away from fumes; allow 3 ft space.
Ensure all connections are made to cabinet, supported independently, use unions, and bypass piping.
Check voltage, install fused disconnect, wire separately from compressor, ground unit.
Compressor, condenser, evaporator cycle refrigerant to cool air and remove moisture.
Step-by-step guide for initial dryer startup and connection.
Procedures for checking refrigerant charge and oil levels for proper dryer operation.
Troubleshooting steps for identifying and diagnosing evaporator leaks.
Explains E1 error for open dew point sensing circuit and troubleshooting steps.
Explains E2 error for shorted dew point circuit and troubleshooting steps.
Explains E3 error for high super heat and automatic shutdown to prevent seizure.
Explains E4 error for freeze protection and potential unloader valve issues.
Explains E5 error for high dew point and potential unloader valve or compressor issues.
Explains E6 error for low suction pressure and potential low freon or switch issues.
Continues troubleshooting for E6, including pressure switch and unloader solenoid.
Explains E7 error for high head pressure and potential overload or condenser issues.
Continues troubleshooting for E7, covering condenser performance and Freon charge.
Explains E9 error for drain shutdown and alarm reset procedures.
To Next Page
General