Why Airwell Air Conditioner indoor unit doesn't respond to the remote control?
If your Airwell Air Conditioner indoor unit isn't responding to the remote control, the remote control message may not be reaching the indoor unit. First, check the remote control batteries. If they are OK, inspect the display and display wiring. If they are OK, replace the display PCB. If the issue persists, replace the controller.
What to do if Airwell AWSI-HJD009/012-N11 indoor unit is leaking water?
If you notice water leaking from your Airwell Air Conditioner indoor unit, it's likely that the drainage tube is blocked. Inspect the drainage tube and clear any blockage.
How to fix Airwell Air Conditioner when indoor fan doesn't start?
If the indoor fan of your Airwell Air Conditioner doesn't start (louvers are open and the Green LED is ON), here are a few possible reasons and solutions: * If the unit is in heat mode and the coil is not yet warm, try changing to cool mode. * If the outdoor unit is in the opposite mode, change the operation mode. * If there is a problem with the controller or capacitor, change to high speed and check the power supply to the motor. For triack controlled motors, it should be higher than 130VAC; for fixed speed motors, it should be higher than 220VAC. If the power supply is OK, replace the capacitor. If not, replace the controller.
What to do if Airwell Air Conditioner units have water leaks and operate with no capacity?
If one or more Airwell Air Conditioner indoor units are operating in cool mode with no capacity, while other units have water leaks or freezing problems, it's likely that the communication wires of the indoor units are switched. Check the communication wire connections and correct them.
Why Airwell AWSI-HJD009/012-N11 red LED indicator is not lit?
If the red LED power supply indicator on your Airwell Air Conditioner indoor unit isn't lit, it indicates a lack of power supply. Check the power supply. If the power supply is OK, check the display and display wiring. If the display and wiring are OK, replace the controller.
Why Airwell AWSI-HJD009/012-N11 green LED indicator doesn't light up?
If your Airwell Air Conditioner indoor unit responds to the remote control but the green LED operate indicator doesn't light up, there might be a problem with the display PCB. Replace the display PCB. If the issue persists, replace the controller.
Why Airwell AWSI-HJD009/012-N11 fan works when unit is OFF?
If the indoor fan of your Airwell Air Conditioner is running when the unit is off, and the fan speed cannot be adjusted with the remote, this indicates a controller problem. Replace the controller.
General| Power Supply | 220-240V, 50Hz |
|---|---|
| Type | Split System |
| Cooling Capacity | 9000 BTU/h |
| Noise Level (Indoor) | 24 dB |
| Noise Level (Outdoor) | 50 dB |
To Next Page