12a-28
CONTROL SYSTEM
Revision 0
12A.12. Forced operation
Forced operation allows units to start, stop and operate in Cooling or Heating in pre-
set temperature according to the following table:
Forced operation mode Pre-set Temp
Cooling 22°C
Heating 28°C
Note:
• While under the forced operation, the temperature compensation
schedule is disabled.
• The forced operation is activated when the mode button on the
Display Board is used to switch the unit to Cool or Heat mode.
• The IFAN is always set to Auto fan Speed in forced operation.
• The backlight will be ON when button is pressed.
To Next Page
Loading...
Need help?
General
