Why does my Airwell GC 9 DCI Air Conditioner go into protection mode and stop the compressor for no clear reason?
If your Airwell Air Conditioner goes into protection mode and stops the compressor without a clear reason, it could be a control problem or a refrigeration system issue. Perform diagnostics (See 13.1.3 below), and follow the actions described.
Why is the indoor fan of my Airwell Air Conditioner working when the unit is OFF, and the fan speed cannot be adjusted?
If the indoor fan of your Airwell Air Conditioner is running when the unit is off, and the fan speed cannot be adjusted with the remote, there is likely a PCB problem. Replace the controller.
Why is my Airwell GC 9 DCI compressor motor noisy with no suction?
If the compressor motor on your Airwell Air Conditioner is generating noise but there's no suction, the phase order to the compressor might be wrong. Check the compressor phase order.
What to do if the compressor of Airwell GC 9 DCI is overheated and the unit does not generate capacity?
If the compressor of your Airwell Air Conditioner is overheating and the unit isn't generating capacity, there may be an EEV (Electronic Expansion Valve) problem. Check the EEV.
General| Type | Split System |
|---|---|
| Cooling Capacity | 9000 BTU/h |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Power Consumption (Cooling) | 800W |
| Operating Temperature (Cooling) | 18°C to 43°C |
| Operating Temperature (Heating) | -7°C to 24°C |
To Next Page
