AUTO FLAP
(LOUVRE)
The air flap (louvre) is automatically positioned for the most suitable blow-out
angle, when COOL, HEAT, DRY or FAN modes are selected. When the air
conditioner is turned off, the flap will close automatically for an aesthetic
appearance.
ON UNIT
OPERATION
Freezes the last operation setting on the remote control. When LOCK is
activated, the remote control will not be able to control the air-conditioner
.
A soft buzzer will sound from indoor unit display to indicate that a
command sent by the remote control has been accepted and stored in the
unit’s memory. This feature may be easily cancelled bu the user from
the display panel.
BUZZER
HORIZONTAL
AIR SWING
Automatic swing of Horizontal air flow in Horizontal direction.
The flap move automatically in right and left direction to spread the
conditioned air evenly throughout the room.
VERTICAL
AIR SWING
Automatic swing of supply air in vertical direction. The flap moves
automatically in upward and downward direction to spread the conditioned
air evenly throughout the room.
Measures and displays room temperature.
ROOM
TEMPERATURE
The air conditioner can be turned ON for COOLING or HEATING or be
turned OFF directly from the indoor unit display panel without the use
of the remote control.
LOCK
3-MIN
DELAYED RUN
This compressor is protected by a three minute delayed restart.
The microprocessor retains the last data entry whether or not the unit is
plugged in. Therefore, when the unit restarts after a power disruption or
failure, it will resume operating in the same mode as before the power
was disrupted.
MEMORY
This function can induct the fresh air from outside into the room and make
your room more fresh.
FRESH AIR
(optional)
They are capable of capturing small particles down to 0.1 microns,
such as atmosphere and household dust, coal dust, insecticide dust,
mites, pollen, pet danger, tobacco smoke particles, cooking smoke and
grease, mould fungi, bacteria, viruses and more.
ELECTROSTATIC
FILTER
IONIZER makes the air more fresh and more comfort.
Slide switch (O) to the ON position and use the remote control to activate the
IONIZER. The blue light indicator (N) on the unit will light up indicating the
IONIZER in operation. To cancel the operation set slide switch to OFF
position. Important Notice: When the air conditioner is turned OFF or if
the indoor fan stops operation the IONIZER stops automatically.
IONIZER
5
To Next Page
Loading...
Need help?
General
