6
OPERATION PROCEDURE
HEATING OPERATION WITH AUTO FAN MODE
This operation starts with the highest air flow in order to quickly raise the room
temperature. It will then automatically switch to a lower air flow to quietly maintain
the selected temperature. HEATING with AUTO FAN will automatically provide the
user with the HOT KEEP function. The fan will be turned off when the indoor coil
temperature is not sufficiently hot to prevent uncomfortable cold air drafts.
HEATING OPERATION
Select the HEATING mode by pressing MODE button (2). Switch to the desired
FAN SPEED or to AUTO FAN by pressing FAN button (4). Select suitable
temperature setting.
COOLING OPERATION WITH AUTO FAN MODE
This operation starts with the highest air flow in order to quickly lower the room
temperature. It will then automatically switch to the low air flow to quietly maintain
the selected temperature.
COOLING OPERATION
Select the COOLING mode by pressing MODE button (2). Switch to the desired
FAN SPEED or to AUTO FAN by pressing button (4). Select suitable temperature
setting.
VENTILATING OPERATION
Select the ventilating mode by pressing MODE button (2). Switch to the desired fan
speed by pressing FAN speed button (4).
TURNING ON THE AIR CONDITIONER
Press START/STOP button (1) to turn the air conditioner on. After connecting to the
power supply. The indicator ( C ) on the air conditioner light up, indicating that the
air conditioner is in the standby status. Please note that the LCD operation display
(13) will always show the last mode of operation and previous function used. If you
want to change the control settings, proceed according to the following instructions.
Otherwise, the air conditioner will start and operate in the same mode and functions
prior to being turned off.
To Next Page
Loading...
Need help?
General
