SLEEP FUNCTION
Press the SLEEP button (7) to select the SLEEP function. When the sleep function
is activated the air conditioner will be automatically turned OFF after seven hours. If
at the same time, TIMER is activated, as well, the air conditioner will be turned ON
and OFF according to the TIMER setting. To cancel the SLEEP function press on
one of the following:
START / STOP button (1)
SLEEP button (7)
I FEEL FUNCTION
Press I FEEL button (3) to activate the I FEEL function. Thermometer sign will
appear on the LCD operation display (13). Select suitable temperature setting.
Make sure that the remote control unit is aimed at the air conditioner, with the I
FEEL sensor (14) in front. Prevent the I FEEL sensor from being affected by heat
sources such as lamps, heaters, direct sun, etc. or from being directly affected by
the air conditioner air flow. These may cause the sensor to transmit the wrong
temperature data, thereby disturbing the performance of the I FEEL function.
SELECTING THE TEMPERATURE
Press TEMP buttons (5) or (6) to change the temperature setting in the LCD
operation display (13). The temperature setting is shown in degrees centigrade. A
higher number indicates a higher room temperature. A lower number indicates a
lower room temperature
DRY OPERATION
Select the DRY mode by pressing MODE button (2). Select the suitable
temperature setting. While in DRY mode, the air conditioner will operate at low fan
speed, regardless of the fan setting on the LCD operation display. Fan might
terminate operation from time to time to prevent from over cooling.
AUTO COOLING / HEATING OPERATION
Select the AUTO mode by pressing MODE button (2). Switch to the desired FAN
SPEED or to AUTO FAN by pressing button (4). Select suitable temperature setting.
The air flap will automatically move to either horizontal air delivery for cooling or to
vertical air delivery for heating. At start, the air conditioner will select its mode of
operation according to the room temperature and the temperature setting.
7
To Next Page
Loading...
Need help?
General
