Airzone Flexa 3.0 - Page 20

16
EN
• Protection mode
1
. (Only for Airzone Cloud) This allows you to disable the delay in the
closing of the motorized elements.
• BACnet
1
. (Only in installations with AZX6BACNET) This parameter shows the device ID,
uplink port, IP address, subnet mask and gateway IP and allows you to modify them. Click
on the desired value, modify the parameters and click on the option to conrm. The default
values are:
- Device ID: 1000
- Port: 47808
- IP address: DHCP
• Centralized control. This allows you to dene whether or not your installation has a
centralized controller. By default, it will be congured as deactivated.
1
Parameters not available in Airzone Blueface zero thermostats