Airzone Flexa 3.0 - 2 pipes; 4 pipes Parameters

19
EN
• Activation delay. This allows you to select a delay time for switching on the production unit,
congurable in minutes, from 0 to 7 (by default, 3 min.).
• DHW function. (Only available in installations with AZX6GAW[XXX] gateway) This allows
you to activate or deactivate (On/Off) the domestic hot water (DHW) function in the systems
connected to the CCP. Function activated by default.
• Cooling mixing valve. (Only available in installations with AZX6GAW[XXX] gateway) This
allows you to congure the operation of your installation depending on whether or not you
have a cooling mixing valve.
Select Manual in the case of having cooling mixing valves in your installation, in which case
they must be set at 18 °C. If the installation does not have a cooling mixing valve, select Auto
so that the installation works automatically with the temperature read by the system. By
default, it is set to Manual.
• LWT temperatures. (Only available in installations with AZX6GAW[XXX] gateway, provided
that the air to water unit is not congured to work automatically, allowing the imposition
of working temperatures) This allows you to dene the LWT temperatures of the air to
water unit for cooling and heating modes. The temperature range is dened by the AC unit.
Default values:
- Air in cooling mode: 10 ºC
- Radiant in cooling mode: 18 °C
- Air in heating mode: 50 °C
- Radiant in heating mode: 35 °C
Mode Demand
Control relays
O1 O2 O3 O4 O5 O6
Stop Off - - - -
- -
Cooling
Air ON - ON - - -
Radiant ON - - ON - -
Off ON - - - - -
Heating
Air - ON - - ON -
Radiant - ON - - - ON
Off - ON - - - -
Dry
On ON - - - - -
Off ON - - - - -
Ventilation
On - - - - - -
Off - - - -
- -
1.
2. 2 pipes / 4 pipes*
*Note: In this conguration, the indoor unit will remain in Standby mode once comfort has
been reached in all zones.