Need help?Do you have a question about the Aiwa AD-F660U and is the answer not in the manual?
General| Track System | 4-track, 2-channel stereo |
|---|---|
| Tape Speed | 4.76 cm/s |
| Motor | DC Servo Motor |
| Type | Cassette Deck |
| Heads | 1 x Playback, 1 x Erase |
| Tape Type | type I, CrO2, Metal |
| Input | Line In |
| Output | Line Out |
| Dimensions | 430 x 140 x 300mm |
| Power Supply | AC 120V, 60Hz |
Lists types of ICs, transistors, diodes, LEDs used.
Specifies voltage and frequency requirements for different models.
Details the electrical power draw.
Provides physical size in mm and inches.
States the unit's weight in kg and lbs.
Describes the audio track configuration.
Specifies the standard tape speed.
Quantifies tape speed variations.
Describes the auto-stop mechanism.
Details the auto-shutoff timing.
Specifies the pressure applied by the pinch roller.
Indicates the torque for the take-up reel.
Specifies torque for fast forward and rewind.
Gives the time for FF/REW on a C-60 tape.
States the acceptable error for the tape counter.
Measures the time for cassette lid operation.
Specifies the standard output voltage.
Quantifies the noise level during playback.
Measures signal isolation between stereo channels.
Procedure to adjust bias oscillator frequency.
Steps to set playback sensitivity.
Adjusting CrO2 record/playback frequency response.
Procedure for adjusting the Dolby-HX circuit.
Adjusting CrO2 record/playback sensitivity.
To Next Page
