Aiwa CSD-EL33 User Manual

TAPE PLAYBACK
TAPE OPERATIONS
TAPE/REVERSE
OPEN mark
MODE
OoOo00
oooo0
ooo0000
ex
INSERTING A TAPE
Use Type I (normal) tapes only.
Press the TAPE/REVERSE MODE button and press
the OPEN mark to open the cassette holder.
Insert a tape with the exposed side facing forward. Push the
cassette holder to close.
To select a reverse mode
Each time the TAPE/REVERSE MODE button is pressed,
the reverse mode changes.
Lz —s¢z-s¢2)-1
To play one side only, select =.
To play from front side to back side once only, select C=.
To play both sides repeatedly, select (=).
PLAYING BACK A TAPE
Insert a tape.
Press the <> button (or the > button on the
remote control) to start play.
Playback side of the tape
The tape counter indicates
the tape running length
“4: The side facing upward is being played (forward).
b: The opposite side is being played (reverse).
To stop play, press the MH button.
To pause play, press the II button. To resume play, press
again.
To change the playback side, press the <4 button in play
mode.
To fast forward or rewind, press the << or B® button in
stop mode. Then press the I button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE/REVERSE MODE button. The power is
turned on and play of the inserted tape begins.
To set the tape counter to 0000
Press the lf button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
¢ To prevent accidental erasure, break off the plastic
tabs on the cassette tape with a screwdriver or other
pointed tool after recording.
Tab for side A
To record on the tape again, cover the tab openings
with adhesive tape, etc.
* 120-minute or longer tapes are extremely thin and
easily deformed or damaged. They are not
recommended.
¢ Take up any slack in the tape with a pencil or similar
tool before use. Slack tape may break or jam inthe
mechanism.
ENGLISH 7

Aiwa CSD-EL33 Specifications

General

Brand	Aiwa
Model	CSD-EL33
Category	Cassette Player
Language	English