Aiwa CSD-EL33 User Manual

RADIO RECEPTION
MANUAL TUNING
7 Press the RADIO/BAND button repeatedly to
select the desired band.
ieee —»> MW —> LW a
lf the power is turned off, the previously tuned station will
be played (Direct Play Function).
When using the remote control, press the BAND button
repeatedly while the power is on.
2 Press the <4 or > button to select a station.
Each time the button is pressed, the frequency changes.
During FM stereo reception, "STEREO" is displayed.
STEREO
frequency
To search for a station quickly (Auto Search)
Keep the << or ® button pressed until the radio starts
searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the << or DP
button.
* The Auto Search may not stop at stations with very weak
signals.
For better reception
FM
Extend the FM antenna and orient it for the best reception.
MW/LW
The MW/LW antenna is inside the unit. Position the unit for
the best reception.
8 ENGLISH
When an FM stereo broadcast contains noise
Press the MODE button on the remote control.
MONO appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, repeat the above again.
To change the MW tuning interval
The default setting of the MW tuning interval is 9 kHz/step. If
you use this unit in an area where the frequency allocation
system is 10 kHz/step, change the tuning interval.
Press the POWER button while pressing the RADIO/BAND
button.
To reset the interval, repeat this procedure.
NOTE
When the MW tuning interval is changed, all preset stations
(see "PRESETTING STATIONS") are cleared. The preset
stations have to be set again.

Aiwa CSD-EL33 Specifications

General

Brand	Aiwa
Model	CSD-EL33
Category	Cassette Player
Language	English