Do you have a question about the Aiwa CX-JN77 and is the answer not in the manual?
Type | Car Receiver |
---|---|
Media Type | CD, Radio |
Tuner Bands | FM |
Output Power | 45W x 4 |
Dimensions | 178mm x 50mm |
Detailed specifications for the CD player, tape deck, and tuner functionalities.
Step-by-step disassembly procedures for major components.
Procedures for electrical adjustments and introductory notes for diagrams.
Precautions for handling optical pick-up blocks and checking laser diodes.
A visual flowchart detailing the entire disassembly sequence.
Procedure to check the S-curve waveform for proper CD focus.
Procedure to check the RFAC signal level for CD playback quality.
Block diagram illustrating the servo system architecture.
Schematic block diagram of the main section, part 1.
Block diagram detailing the panel and power supply circuitry.
Printed wiring board layout for the CD board, component side.
Detailed schematic diagram of the CD board circuitry.
Printed wiring board layouts for the changer section components.
Schematic diagrams for the changer section components.
Printed wiring board layouts for CDMP3 connect and translation boards.
Schematic diagrams for CDMP3 connect and translation boards.
Schematic diagram of the main board, part 1.
Schematic diagram of the main board, part 2.
Schematic diagram of the main board, part 3.
Schematic diagram of the main board, part 4.
Printed wiring board layouts for the main board.
Printed wiring board layout for the panel board.
Schematic diagram of the panel board, part 1.
Schematic diagram of the panel board, part 2.
Printed wiring board layout for the power amp section (AEP, UK, CIS).
Schematic diagram for the power amp section (AEP, UK, CIS).
Printed wiring board layout for the power amp section (E51, MX).
Schematic diagram for the power amp section (E51, MX).
Printed wiring board layout for the TRANS section (AEP, UK, CIS).
Schematic diagram for the TRANS section (AEP, UK, CIS).
Printed wiring board layout for the TRANS section (E51, MX).
Schematic diagram for the TRANS section (E51, MX).
Examples of waveforms observed on the CD board.
Block diagrams of ICs used on the CD board.
Block diagram for IC301 on the main board.
Block diagram for IC101 on the main board.
Description of pin functions for IC371 on the main board.