Aiwa HS-J700 - Disassembly Instructions; Removing Cassette Lid; Removing Control Panel; Removing Rear Cabinet

DISASSEMBLY INSTRUCTIONS
1. Removing Cassette Lid 4. Removing Cassette Holder
(See Figure-1) Ass” y (See Figure-3)
SCREW @ (V+1.4-1.4) X2 SCREW (@) (HINGE SCREV 1.4-1) X1
Hook X 2 ; STEX1
H ook
Cassette holder Ass’y
Atey kAILY— Ass’y
fey hI Ass’ y Be
‘ ‘ oe
Cassette lid Ass’y C®
Fig. 1 Fig. 3
2. Removing Control Panel
(See Figure-2) 5. Removing Circuit Board
SCREW (SCREW, CABINET M1.4) X2 (See Figure-4)
SCREW (€) (SPECIAL SCREW V+1.4-2.5) X2 scREW © (V+1.4-3) x1
Remove it in the direction of the arrow @. SCREW @ (V+1.4-2.2) x1
3. Removing Rear Cabinet Unsolder the preset volume circuit board.
(See Figure-2)
SCREW ®O (SPECIAL SCREW V+1.4-1.8) X3 Note) To operate the mechanism without the circuit board,
SCREW @ (SPECIAL SCREW V+1.4-2.5) x3 short-circuit the pattern and chassis shown by the
Knob X 2 arrows uSing a jumper to prevent the auto-stop
Remove it in the direction of the arrow @. feature from malfunctioning.
Pity bE s-LER HHA SH
Pre—Set VR CB Unsolder it
ERLE? S RIL
Control! panel
b~~--;~-—
<
|
i
I
!
!
L
| t !
cara
em |
bees
8
@)
rt |
|
euy-TIU—h
Center frame
a) Fig.4