Aiwa HV-E212 - Page 11

7. “Tape Guide Flange A” and “ACE Head” Removal (See Figure — 6)
l. “Tape Guide Flange A” Removal
1) Remove Nut @).
2) Take out the “Impedance Reller” and pull up the “Tape Guide Flange A”.
2. “ACE Head” Removal
1) Remove 2 screws (@)x 1, (Ox 1) and “Azimuth Spring”.
2) Remove 1 screw (@)) and “ACE Head”.
@.
(a)
= Impedance Roller (8)
Azimuth Spring and; (C)
2 &
Tape Guide Flange A —t
©
|
Tape Guide Flange a ACE Head gD)
J
ay
ea
Ner
Nut
& i)
Plane Washer 3 x 8 x 0.5
Impedance Roller a,
Head Base
s-- Tracking Adjuster
Head Spring
a
Fig.-6
11