Aiwa HV-E212 - Page 17

15. “Loading Gear” and “Loading Cam” Removal (See Figure — 14)
1) Take off the “Loading Belt” from the “Loading Pulley”.
2) Remove Poly — Washer @) and take off the “Loading Pulley”.
3) Remove Poly — Washer @) and take off the “Loading Gear”.
4) Remove Poly — Washer © and take off the “Eject Actuate Arm” and the “Brake Actuate Arm”.
5) Remove 2 screws ©). and take off the “Loading Lever Reinforce Plate” and the “Loading Lever ASSY”.
6) Take off the “Loading Cam”.
Loading Lever Reinforce Plate @ (0)
Loading Lever ASSY
Loading Cam
Loading Gear
Loading Belt
Fig.-14
17