To Next PageTo Next Page
Need help?Do you have a question about the Aiwa HV-GX900 K and is the answer not in the manual?
General| Tape Format | VHS |
|---|---|
| Number of Heads | 4 |
| Hi-Fi Audio | Yes |
| Remote Control | Yes |
| ShowView | Yes |
| Tuner | Yes |
| Playback Speed | SP/LP |
| Inputs | RF |
| Outputs | RF |
Instructions for removing the main casing and operation boards.
Procedure for removing the front flap assembly.
Steps to detach the main VCR deck mechanism.
Guide for removing the System Control PCB.
Instructions for removing the top bracket component.
Steps for removing the deck cover, flap lever, and tape guide.
Procedure for removing the left tape guide.
Steps to remove the cassette loading mechanism.
Instructions for removing the cassette side components.
Procedure for removing the internal link assembly.
Steps to detach the loading motor assembly.
Instructions for removing the left sensor cover.
Procedure for removing the tape tension mechanism.
Steps to detach the T brake assembly.
Instructions for removing the supply and take-up reel assemblies.
Procedure for removing pinch roller and related parts.
Steps to detach the Audio/Control head.
Instructions for removing the Full Erase head.
Procedure for removing the cylinder unit and associated assemblies.
Steps to detach the Capstan Direct Drive unit.
Instructions for removing the middle gear and main cam.
Procedure for removing the clutch assembly.
Steps to detach the loading gear assemblies.
Instructions for removing the inclined S and T assemblies.
Procedure to check the total operating hours of the VCR.
Guidelines for cleaning key components like heads and tape path.
General notes and initial checks before mechanical adjustments.
Steps to adjust reel disk height for proper tape path.
Procedure to set the correct position of the tape tension post.
Method to verify playback torque and back tension.
Procedure to check the VSR torque.
Steps to check S Reel and T Reel brake torque.
Procedures for confirming and adjusting tape transport.
Instructions for adjusting the guide roller for tape path accuracy.
Steps to confirm and adjust the audio/control head position.
Procedure for adjusting the X value for tape running.
Diagram showing the location of parts for mechanism adjustments.
General notes and initial steps for electrical adjustments.
Procedure to adjust the Pulse Generator (PG) shifter.
Diagram showing the location of parts for electrical adjustments.
Troubleshooting steps for when the unit fails to power on.
Diagnostic guide for issues where the VCR unexpectedly powers off.
Troubleshooting steps for a non-rotating cylinder motor.
Diagnostic guide for problems causing audio instability or shakiness.
Troubleshooting steps for when the VCR does not accept a cassette.
