Aiwa NSX-DS50 - Page 11

ECO mode
Reduces power consumption with the following operations, efc.
ECO ON mode
The unit blacks out when the unit is turned off. Only the red
indicator lights up. (Only when the clock is set.)
- If dimmer mode is set to on, the unit illumination brightens
(for 10 seconds) only when you operate the unit.
When the unit turns on with the timer recording, the dimmer
mode is set to dimmest and the volume is set to minimum.
ECO AUTO mode
- In addition to the operations of ECO ON mode, the unit
1
2
automatically turns itself off if you do not operate the unit
and the sound source is mute for 10 minutes except when
external digital input is selected.
Press DEMO/ECO once when the unit is turned
on, and then within 4 seconds press ENTER.
Turn MULTI JOG to select one of the ECO modes
and then press ENTER.
if there is no MULTI JOG or button operation within 4
seconds, the setting is canceled.
To cancel the ECO mode
Repeat the above and select "ECO OFF’.
Dimmer
Adjusts the brightness of the display.
1
2
Press DEMO/ECO twice when the unit is turned
on, and then within 4 seconds press ENTER.
Turn MULTI JOG to select one of the three dimmer
modes or "DIM-OFF", and then press ENTER.
“DIM-OFF" is the brightest and "DIMMER 3" is the
dimmest.
If there is no MULTI JOG or button operation within 4
seconds, setting is canceled.
To cancel the dimmer
Repeat the above and select "DIM-OFF".
seftieg the clock
2
Press CLOCK on the remote control.
Press <¢<4 or > to set the time.
Each press changes the time in 1-minute steps. Holding
it down changes the time in 10-minute steps.
If <4<4 or BP is not pressed within 4 seconds, setting
is canceled.
© MULTI JOG is also available in place of << or >>.
Press ENTER or #ESET.
The time display stops flashing and the clock starts from
00 seconds.
To display the time
Press CLOCK on the remote control.
The time will be displayed for 4 seconds, but it cannot be
displayed during recording.
To switch to the 24-hour standard
Display the time and press I within 4 seconds.
With each press, the clock alternates between the 12-hour
standard and the 24-hour standard.
Tip:
In the 12-hour standard, "AM 12:00" indicates midnight
and "PM 12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Re-set the clock.
11