Check the signal level at the installation location
If the signal level is low (one bar), we cannot guarantee stable operation of the
security system. Take all possible measures to improve the quality of the signal!
As a minimum, move the device — even 20 cm shift can signicantly improve
the quality of the reception.
If after moving the device still has a low or unstable signal strength, use a
.
The detector is located either inside or outside of the door case (window frame).
When installing the detector in the perpendicular planes (inside the case/frame),
use the small magnet. The distance between the magnet and detector should
not exceed 1 cm.
When positioning the parts of DoorProtect in the same plane, use the big
magnet. Its actuation threshold — 2 cm.
Attach the magnet to the moving part of the door (window) to the right of the
detector. The side to which the magnet should be attached is marked with an
arrow on the detector’s body. If necessary, the detector may be positioned
horizontally.
Installing the detector
radio
signal range extender
To Next Page
Loading...
Need help?
General
