The test does not start immediately, but the waiting time does not exceed the duration of
one detector ping interval. The default value is 36seconds. You can change the detector
ping interval in the Jeweller (or Jeweller/Fibra) menu in the hub settings.
Icons
The icons show some detector states. You can view them in Ajax app in the
Devices tab.
Icon Meaning
Jeweller signal strength between the detector and the hub or the radio signal
range extender. The recommended values is two or three bars.
Battery charge level of the device.
The Interconnected Fire Detectors Alarm feature is activated.
The detector operates in the Always Active mode.
The icon is displayed permanently. FireProtect 2 is always active and responds
to a re 24/7, regardless of the system’s security mode.
2. Go to the Devices menu.
3. Select FireProtect 2 (Heat/Smoke).
4. Go to the settings by clicking on the gear icon .
5. Select Jeweller Signal Strength Test.
6. Perform the test following the tips in the app.
Learn more
Learn more
Learn more
Learn more
To Next Page
Loading...
Need help?
General
