Parameter Meaning
Temperature
Air temperature in the room where FireProtect 2
is installed. Measured in Celsius or Fahrenheit
degrees depending on the app settings.
In the normal state, the temperature value is
displayed in black.
When the temperature rises, the eld is
highlighted with red.
Jewellers Signal Strength
Jeweller signal strength between FireProtect 2
and the hub or radio signal range extender.
The recommended value is two or three bars.
Jeweller is a protocol for transmitting
FireProtect 2 events and alarms.
Connection via Jeweller
Connection status between FireProtect 2 and
the hub or radio signal range extender via
Jeweller:
Battery Charge The battery charge level of the device:
When the batteries are discharged, users and
the CMS receive a notication.
After the low battery notication, the detector is
able to operate for another month under normal
conditions. In case of an alarm, the battery
charge is enough to ensure 4 minutes of the
sound and LED indication operation.
Online — the detector is connected to the
hub or range extender. Normal state.
Oine — no connection between the
detector and the hub or range extender.
Check the detector connection.
OK — detector batteries have sucient
charge. Normal state.
Battery low — detector batteries are
discharged.