AJAX FireProtect 2 - Page 17

You can replace batteries in a detector with
replaceable batteries only (has RB in its name).
A detector with sealed batteries (has SB in its
name) should be replaced with a new one after
the batteries are discharged.
Lid
The state of the detector’s tamperthat
responds to detachment of the device from the
surface or opening of the enclosure:
Smoke
Smoke sensor state:
Ifsmoke is detected, the text eld highlights
red.
Temperature Threshold Exceeded Alarm state if temperature threshold is
exceeded:
How the battery charge is displayed
Battery life calculator
How to replace batteries in
FireProtect 2 RB (Heat/Smoke)
Open — the detector is removed from the
SmartBracket mounting panel, or the
enclosure integrity is violated in another
way. Check the mounting of the detector.
Closed — the detector is installed on the
SmartBracket mounting panel. The integrity
of the device enclosure and the mounting
panel is not violated. Normal state.
Learn more
Clear — normal state, the detector does not
detect smoke.
Alarm — the detector detects smoke.
Learn more
No — normal state, the detector does not
detect temperature threshold exceeding.