NOTE
After the X-ray tube has been warmed up (approx. 1∼2sec.), the exposure
can be released without delay. This helps to eliminate motion artifacts.
The lamp will go out, If beam limiting device lamp is glowing until exposure
release switch is pressed.
3)
Press the exposure release switch to
exposure condition(i.e. second position)
and hold until the exposure is finished.
During the X-ray exposure,
the exposure indicator glows yellow and
an audible signal sound.
NOTE
The exposure ends immediately after the operator stops pressing the
exposure release switch. ( deadman's function )
-------------------------------------------------------------
AJEX240H / Operating instructions -24-
AXR-240H-MN01 (E) / Rev. 03
To Next Page
Loading...