a) Press enter key, then error mode will be returned normal radiographic
mode. If error mode is not returned normal radiographic mode,
contact AJEX immediately.
b) Releasing an exposure.
If error code E04 is displayed again on the mAs display, contact
AJEX immediately.
☞ Refer to page 28. 6-3. Service
5) ERROR code E05 ; Overheat error
Error code "E05" is displayed when single tank or heat sink is overheated.
a) Wait until single tank is cooled, then error mode will be returned
normal radiographic mode.
-------------------------------------------------------------------------
AJEX240H / Operating instructions -32-
AXR-240H-MN01 (E) / Rev. 03
To Next Page
Loading...