AJP PR5 250 - ENGINE OIL RECOMMENDATION

AJP PR5 User’s manual – 2nd Edition Page
9
To adjust rebound, turn the screw
placed on the bottom of the shock
absorber (3) clockwise for more
rebound or counter clockwise for less
rebound.
To adjust fast compression damping,
turn the knob (4) clockwise for more
rebound speed. To reduce rebound
speed turn counter clockwise.
To adjust low compression damping,
turn the screw (5) clockwise for more
rebound speed. To reduce rebound
speed turn counter clockwise.
Standard set-up:
- Spring length: Enduro 205mm;
Supermoto 210mm
- Damping force: turn all to close
position (+) and then turn 20 clicks
to open (-)
- Rebound: turn all to close position
(H) and then turn 10 clicks to open
(S)
! WARNING !
Improper servicing of the rear shock
absorber assembly is dangerous.
The rear shock absorber contains
high-pressured gas and can explode
if improperly serviced.
ENGINE OIL
RECOMMENDATION
Use a premium quality 4-stroke motor
oil to ensure longer service life of your
motorcycle. Use only oils that meet or
surpass quality requirements of API
classes SF or SG:
SAE 10W/40 or 15W/40 API SF or SG
Oil level
Engine oil level can be checked in the
glass in front of rear brake pedal. Oil
level should be between the two lines in
the glass. If oil level is below the lower
line, refill immediately. If your engine is
losing oil, contact an AJP dealer
immediately.
! WARNING !
Insufficient oil or poor quality oil
results in premature wear of the
engine and may cause severe
damages!