Akai 1730-SS

VII. MAINTENANCE PROCEDURE
i
ie
FLYWHEEL @ | drop MOTOR
1. LUBRICATION INSTRUCTIONS
For maximum service life and optimum performance,
lubricate the following parts after each 500 hours of
operation. Use only light machine oil of good quality.
Motor
Flywheel Assembly
Rewind Idler Whee! and Wind Take-Up Idler 1 drop
Intermediate Idler 1 drop
Pinch Wheel 1 drop
Also apply a liberal film of light machine grease to
each roller surface of all levers and cams.
CAUTION: DO NOT OVER-LUBRICATE. WIPE OFF
EXCESS OIL WITH A COTTON SWAB SOAKED
IN ALCOHOL. OTHERWISE, EXCESS LUBRI-
CANT MAY BE SCATTERED DURING OPE-
RATION AND THE RUBBER COMPONENTS
WILLDETERIORATE.
2. CLEANING TAPE HEADS AND OTHER
PARTS
Wipe surface of tape heads, guide roller bearing, capstan
bushing and pinch wheel periodically with a soft cloth
soaked in alcohol.
16