8
USING YOUR APPLIANCE
POWERING ON:
The Portable Radio can be powered with
batteries or using the adaptor.
1. Press the POWER button down to turn
the power supply on.
BATTERIES:
• Open the battery compartment located
at the back of the radio and place
4 x 1.5V /C batteries taking care not
to reverse the poles. Close the battery
compartment.
POWER ADAPTOR:
• Insert one end of the power adaptor
into the DC jack on the back of the
Retro Radio. Plug the other end of the
adaptor in at the mains and turn on.
To switch o completely, unplug the
power cord from the wall outlet.
CONTROLS:
BUTTON FUNCTION
POWER
ALARM OFF
In standby mode, press
to turn the radio on
Press to turn the alarm
o when it sounds
PLAY/PAUSE
TIME
Press to play and pause
playback
Press to enter clock
setting and alarm setting
modes
TU- Press to go to the previ-
ous preset radio channel
TU+ Press to go to the next
preset radio channel
CLK- Press to go back when
setting the time.
BACK Press to skip back on
USB/SD modes. Press to
scan backwards in radio
mode.
CLK+ Press to go forward
when setting the time.
NEXT Press to skip forward on
USB/SD modes. Press
to scan forward in radio
mode.
STOP/SLEEP Press to stop
playback
Press and hold to enter
sleep mode
SNOOZE Press to snooze the
alarm
TUNING YOUR FM RETRO RADIO:
1. Connect the supplied power adaptor
or insert batteries into the battery
compartment.
2. Turn unit on.
3. Extended the Antenna fully.
4. Select FM mode by pressing power/
function button.
5. Press PLAY/PAUSE/TIMER - product
will enter into auto tune and find the
next station.
6. Press CLK -/CLK + to finer tune the
signal.
7. Press MEMORY to store the channel in
1 of the 20 Pre-sets.
8. Press CLK- CLK+ to select the channel
(shown in lower left corner of the LCD).
9. Press MEMORY to select desired pre-
set channel.
10. Repeat for any other required stations.
Note: If a channel is stored over a
previously used pre-set channel the original
stored station will be replaced.
To Next Page
Loading...
Need help?
General
