Cleaning and maintenance6.
Cleaning the cabinet6.1
Wipe with a soft cloth. If the cabinet is very dirty, dampen (not dropping wet)
the cloth with a weak solution of soapy water, and then wipe clean.
Cleaning the connector6.2
Use a cotton swab soaked in isopropyl alcohol to clean the socket on the
back of the control panel. Be sure to clean them carefully pin by pin and
make sure not to damage the connecting points.
Fuse replacement6.3
If the fuse blows, check the power connection and replace the fuse. If the
fuse blows again after the replacement, there may be an internal
malfunction. In this case, consult your reseller.
!
CAUTION
Use the specied amperage fuse for each lead. Use of a higher
amperage fuse may cause serious damage.
Handle and care of a disc6.4
● Hold the disc with ngers. Hold the disc outer edge and/or the centre
spindle hole. Do not touch the disc surface.
● Do not bend or press the disc. Do not expose the disc to direct sunlight or
heating sources.
● Clean the disc surface with a soft, dry cleaning cloth. Wipe the disc
surface gently, radially, from centre towards the outer edge.
● Do not apply thinner, alcohol, chemical solvent, or sprays when cleaning.
Such cleaning uids will permanently damage the disc surface.
To Next Page
Loading...
Need help?
General
